Bar Weight Gap Fix?

[Houtman_imp]

I used a very cheap and quick/simple solution to fill the "ugly gaps" on my 2014 and 2017 bikes.
It might not be a nice as the machined solution but it works.
I used o rings , 20 mm OD and about 3 mm thick.
Use silicon spray/ WD 40 to "oil" the o rings and than you can easily work them over the bar weights.
Since I was a kid I always take things apart before throwing them out and keep all the bolts , nuts , springs and o rings etc. because " you never know "
That is how I ended up with a whole can of o rings and did not have to buy them.
The gap is less obvious on the 2013 as it is all black.