Lookey what I got, Emgo Venom Mark ll

[mvk24_imp]

I had this. Mounting it is a b!tch.

Firstly, if you really want to mount it you need to change the screws that hold the visor. If not it'll scratch the crap out of your buckets. Might have to swap the turn signals for smaller ones. It's a challenge to mount this. Not a direct fit whatsoever. If you figure it share it on the forum. You'll certainly have my attention.

Thanks for the insight! Yes I was thinking I will go get some sort of flush head bolt but a little longer to replace the head light ones.

I can see there is a little bit of space between the fairing and headlight bolt so I think I want to fill that gap with a rubber or silicone washer so when I tighten it all down the stress won't bend the fairing. Its a small amount of space but I dont want to stress the fairing that much on both sides when I lock down the headlight.

There is also a small bracket in the bottom center of the fairing that looks like it will mount to the bolt that holds the horns. A little L bracket there should do the trick.

I will hit the hardware store and grab a few different options for bolts, spacers/washers, and right angle brackets. When I figure out the best option I will relay the sizes of all parts used.

I already have micro turn signals on the way that are 6mm thread so it should just be 1 washer to make it mount flush to the stock mounts on the bike.

Sent from my SM-G965U1 using Tapatalk