Rlet's simple fitting

[Mixagon_imp]

The seams are actually to break up the air flow some to prevent low pressure areas around the lever balls. This has the effect of lowering air resistance so as to allow the bike to go faster. IT WORKS! I verified it at the NASA facility at Wallops Island wind tunnel while doing top secret research on the drones that everyone thinks are UFOs. OH SNAP, wasn't supposed to say anything about that. Well, see you guys in 10 to 20...

I said the small holes in the Rlet balls were there to confuse application but the actual purpose of the holes is they work in conjuction with the seams on the outside which direct the air flow over the holes to make a high pitch whistle at illegal speeds which only dogs and law enforcement can hear and thus generating automatic speeding tickets to be sent out.
Whereas correctly fitted Rlets with seams inside are silent and warp speed is undetectable at any factor.