Rubber Lever End Thingies

[suhawk305]

I think that pretty much says it all.

For Suhawk though, the aftermarket levers may have sub standard sized ball ends and in this instance a measurement should be taken before taking a razor blade to his fake ones. If he were going that route.

Your comment (except your first one) maybe the case. I just measured the OD of the RLET ball ends on both CBs. The CB1100 is about 3mm more than the CB77. OEM RLET material appears slightly thicker than the after market one. BTW: the aftermarket RLET has stretching ability which indicates rubber!

So my question to you Mr. Ferret and your side kick from down under is do I cut-off perfectly good RLETs and risk the OEM RLETs will be too large? I would hate to see the RLETs flying off the levers when the speed limiter kicks in at 114mph. Wait, which CB am I talking about?