08-23-2013, 05:34 AM
Quote:Wonder if this electrical connections coming loose from the switched on the brake and or clutch could be an issue to address with honda??
It is a pair of right angled push on connectors. What I did was push it back on, then cut a piece of 10mm wide Gorilla Duct Tape to wrap around the hand brake clamp bracket and over the top of the connectors. I mounted the tape without jamming up the lever. The tape is about four inches long. I cleaned the surface with alcohol before application. It is under the lever assembly so it cannot be seen and will hold the connector on for at least five years I would think.
If you tell Honda about this, they will just apply the tape at the factory.
Here it is. They should give you a roll of Duct Tape with every new bike.
It is a pair of right angled push on connectors. What I did was push it back on, then cut a piece of 10mm wide Gorilla Duct Tape to wrap around the hand brake clamp bracket and over the top of the connectors. I mounted the tape without jamming up the lever. The tape is about four inches long. I cleaned the surface with alcohol before application. It is under the lever assembly so it cannot be seen and will hold the connector on for at least five years I would think.
If you tell Honda about this, they will just apply the tape at the factory.
Here it is. They should give you a roll of Duct Tape with every new bike.