09-18-2013, 09:54 AM
(09-18-2013, 09:16 AM)Deanohh_imp Wrote:(09-18-2013, 09:04 AM)fishmitch_imp Wrote: i have a good one for you guys. i installed a bazzaz zfi on the cb1100 and when we went to dyno it,everything was good until a little over 6000 rpm . the engine goes real lean and falls out. everything maps good until 6k rpm.we called bazzaz and they had not run into this.i am going to unplug the zfi tommorow and put it back on the dyne to see if it's in the bike or the zfi. has anyone else had a similar problem with their bike? it sounds to me like it might be a bad ECM unit. thanx , mitch
if you were in 5th gear you might have hit the speed limiter. (about 112mph). For dyno you can pull rear wheel speed sensor connection behind r. Side cover. Or run in 3rd gear.
if you were in 5th gear you might have hit the speed limiter. (about 112mph). For dyno you can pull rear wheel speed sensor connection behind r. Side cover. Or run in 3rd gear.
[/quote
it does it in 4th and 5th
when the speed limiter kicks in ,what does the engine do exactly?