11-18-2013, 02:36 AM
Powder coatings need about 340 degrees F / 175 degrees C to cure.
If you had your bearings still in the wheel during that process, guess what happened to the tiny rubber seals and the small amount of lubricant.
In this case have new bearings installed by a professional.
If you had the bearings removed and reinstalled, then probably that killed them. Again: new bearings.
If you had your bearings still in the wheel during that process, guess what happened to the tiny rubber seals and the small amount of lubricant.
In this case have new bearings installed by a professional.
If you had the bearings removed and reinstalled, then probably that killed them. Again: new bearings.