09-28-2018, 12:59 PM
Yes, it was a 5 mm to remove the side covers.
Oh, that would be like not opening presents on a birthday!
The day/night I bring new bike home, seat comes off, side covers come off, stickers get removed (a real pain on the Moto Guzzi), connectors get checked, uncut cable ties get snipped, unruly cables rerouted, etc...then I figure out where to put tools, foot pump, Seal N Air, etc.
BTW, everything was already tidy on the CB1100. I only remember one sticker, on the fuel tank and it came off very easy.
Not much room on the MG V7II, but small Pelican cases fit well:
http://wildguzzi.com/forum/index.php?topic=89090.0
(09-28-2018, 11:12 AM)The ferret_imp Wrote: I think my $ 15,000.00 (retail) ST 1300 came with a vinyl pouch, a 5 mm allen wrench and a rectangular piece of foam. We never did figure out what the foam was for.
I haven't even looked under the seat of my new $16.5K (retail) FJR Yamaha. Have no clue if it came with any tools or not.
Oh, that would be like not opening presents on a birthday!
The day/night I bring new bike home, seat comes off, side covers come off, stickers get removed (a real pain on the Moto Guzzi), connectors get checked, uncut cable ties get snipped, unruly cables rerouted, etc...then I figure out where to put tools, foot pump, Seal N Air, etc.
BTW, everything was already tidy on the CB1100. I only remember one sticker, on the fuel tank and it came off very easy.
Not much room on the MG V7II, but small Pelican cases fit well:
http://wildguzzi.com/forum/index.php?topic=89090.0