Using Nolan N104 with helmet lock

[Destindoc_imp]

I appreciate your responses.... I have a Goldwing as well and do have the Nolan T bar extension too, I do occasionally use it on the GW. I believe the hole in it is too small for the CB helmet lock, but I haven't looked. If it is too small, I thought about trimming down the helmet lock metal part that moves up and down just enough for the T bar to work. I'll have to look at that. I do want to be able to use the CB helmet lock.

And, I do have the double wire loop with the rubber coating gizmo... I also have a CBR 1000 RR. It came with that bike, but I've never used it. I just carry the Arai I wear with that bike with me if needed. Typically, I'm out for just a ride on this bike, don't even really take the Arai helmet off unless getting gas etc. And, honestly, I know how this wire connects under the rear seat on the CBR but I never thought about "how" it's suppose to be done.... and wrapping it around the chin bar never occurred to me...... duh....

So, I could wrap this around my chin bar on the Nolan and use the CB lock... I think you guys just solved my problem.

Honda should make this lock as a pin like so many other bikes are, not a flat wide piece of metal... then the T bar extension would work, just as it does on a GW.