Any interest in cams?

[PowerDubs_imp]

Oh it definitely seems a little chatty, because as a safety not only for a loose valve is cool, but a loose valve will also have less chance of contact with the piston, and in theory they really should tighten up as I ride.

Peter – arrow header with staintune muffler.

Never had it tuned on a dyno, just doing my own thing with the power commander and auto tune for now.

Will probably make an appointment and drive out to Guhl in PA to have an actual tuner tonight because he can do ignition curve as well.

So far so good just ran it for 10 minutes between 2-4K, supposedly you never want to let new cams go below that for the first 15-20 minutes because they need as much oil being sprayed around in the head as possible.

I stopped to check the air fuel on the laptop to see what the trim table was showing about the hop back on do another 10 minutes all seems well no leaks no odd sounds I will turn probably get dressed then and head out for a quick ride as long as the rain holds off.



Sent from my iPhone using Tapatalk