Any interest in cams?

[max]

Josh how would you verify for yourselves if the cams are what you ordered, i mean; roundness, eccentricity, and all the other variables, v blocks or so?

Thanks for confirming the buckets were well looked after and also interesting to see what the measurements are after the new cams have run in after some time.

Don't think you are the only one with some problems, electronics and radio is an ongoing journey in finding faults and needs some very expensive equipment to find a problem with a 2$ part, sometimes seems not worth it and this is when you are lucky to have friends with the right test gear to overcome these problems but mostly it's just experience and knowing where to look, tricks help too!

max