07-29-2018, 08:27 AM
Ugh. Looks like I am starting over-
Checked step #1, .15 +/- on two of the intake cyls.
Measured last night on the stock cams, adjusted shims to bring in closer to spec.
Just checked on the new cams- .20 slides right in.
Might be manufacture differences, might be reduced base circle.
Time to do all the measurements and adjustments over again.
Sent from my iPhone using Tapatalk
Checked step #1, .15 +/- on two of the intake cyls.
Measured last night on the stock cams, adjusted shims to bring in closer to spec.
Just checked on the new cams- .20 slides right in.
Might be manufacture differences, might be reduced base circle.
Time to do all the measurements and adjustments over again.
Sent from my iPhone using Tapatalk
