05-22-2015, 12:09 PM
You have to get new screws they are different lengths from the 13
You have to remove the left grip ( it's easy with an air compressor but not hard without) because there is a solid plastic ring that must be removed. ( see Tinks post 15 in this thread..also his tute on removing the headlight connector)
Yes you have to drill a new hole for the locator pin. Measure carefully, the grip and the bar end length needs to be considered. If I were to do it again I would mark on the bar where the old switch was with a marker. Then use masking tape, where you need to drill, put the new switch on where you want it without screws and then squeeze it hard to mark the tape where you need to drill, but then again I'm not very handy and mis measured mine the first time.
You have to remove the left grip ( it's easy with an air compressor but not hard without) because there is a solid plastic ring that must be removed. ( see Tinks post 15 in this thread..also his tute on removing the headlight connector)
Yes you have to drill a new hole for the locator pin. Measure carefully, the grip and the bar end length needs to be considered. If I were to do it again I would mark on the bar where the old switch was with a marker. Then use masking tape, where you need to drill, put the new switch on where you want it without screws and then squeeze it hard to mark the tape where you need to drill, but then again I'm not very handy and mis measured mine the first time.