04-14-2015, 10:41 PM
Tink make sure you put the right length screw in the right hole. I wasn't paying attention and when I ran the screw in I dimpled the switch out. Felt the resistance and stopped before poking a hole though.
also locator pin need to be redrilled. Measure twice. It's strange. Test put the switch on the bar and the bar end, and hold the grip up there for length and then put tape marking where the switch sits. I'm sure you will figure it out. I drilled mine wrong the first time.
also locator pin need to be redrilled. Measure twice. It's strange. Test put the switch on the bar and the bar end, and hold the grip up there for length and then put tape marking where the switch sits. I'm sure you will figure it out. I drilled mine wrong the first time.