04-05-2020, 01:49 PM
(04-05-2020, 01:23 PM)misterprofessionality_imp Wrote:(04-05-2020, 12:54 PM)Ben70_imp Wrote: Ground is as important as power in a circuit. Try grounding the unit to a bare metal engine part with a jumper wire just to see what happens. Or to battery ground.
Ben
This has yielded no results. i tried to ground it all over the bike using a jumper cable i had laying about. i clipped the green wire to it and tried to hook the cable in various spots on the bike to see if it would produce a result. no dice.
This has yielded no results. i tried to ground it all over the bike using a jumper cable i had laying about. i clipped the green wire to it and tried to hook the cable in various spots on the bike to see if it would produce a result. no dice.
You are grounding the harness ground to ground.
With the red and black wires connected to the new taillight, run the jumper between the base of the new taillight and the green wire.