back pegs

[mdharne_imp]

Any one know of any wider back pegs that will work on 2014 cb1100?

[Lord Popgun]

I seem to recall someone put Harley pegs on. Something wider anyway. I’ll have to do some searching and see if I can find the thread.

Ok, it wasn’t Harley pegs, it was ST pegs: http://cb1100forum.com/forum/showthread....#pid169626

He said he used a 2002 ST1100, but the part number is the same for the 2012 ST1300. I have one and can send you a pic if you want. Notice that you cannot buy a peg. You have to buy all the parts and put it together if you buy Honda OEM parts. Here a a fiche: https://www.partzilla.com/catalog/honda/...0a-ac/step

[Banned_imp]

Or was it Buell pegs? I remember reading about that although I can't remember if they were front or rear.

[Lord Popgun]

W/R, I could only find ST1100, but I didn’t read EVERY post that came up in the search.

A search on Buell pegs brings up a number of posts with them for rider pegs.

[Banned_imp]

I went and looked at my Buell, it's kind of hard to get to and I can't bend over and measure but I don't think Buell pegs would work for the back. If they did fit I don't think they could be folded. Too bad as they are quite roomy, comparatively speaking.

Good thing the ST pegs fit.

[mdharne_imp]

Thanks for checking, Sorry I havent been online in a while had a cold and been laid up.

[PowerDubs_imp]

Anyone have a picture of these st pegs mounted?


Sent from my iPhone using Tapatalk