Sorry Guys Exhaust question again

[Newceebee_imp]

I've got a '13 cast-wheel model fitted with an Arrow end can and it sounds very good without being obtrusive - lighter than the original too.

[jedd_imp]

beardyweirdy Ive PMd you re the above

I also drilled the first plate baffle out it had three little 1/4 holes in it ive drilled that right out with an inch bit it sounds a lot nicer now but would still prefer a 4 into 1
Rob

here's a pic of the cross section of the 2017-2019 muffler (top pic) vs. 2013-2014. There's a better chance of success w/ the 2017 b/c there's one less partition.


also, re: 4:1 off the 2013-2014, you would need to use the rear foot peg bars of the same year b/c the muffler hanger is located much closer to the rr pegs vs. the 2017.

[Adventure boy_imp]

Cheers guys
I think it now sounds very nice so will leave it for now, iv a 4 into one comes up ill have it
Rob