+- The CB1100 Community Forum (https://cb1100forum.net/forum)
+-- Forum: Honda CB1100 Discussions (https://cb1100forum.net/forum/forumdisplay.php?fid=5)
+--- Forum: Accessories/Modifications (https://cb1100forum.net/forum/forumdisplay.php?fid=8)
+--- Thread: Arrow Slip-on Question (/showthread.php?tid=9162)
Pages:
1
2
Arrow Slip-on Question - holy666diver_imp - 12-07-2016
So I just installed the Arrow Slipon on my 2014 cb.
Anyone who has one I have a question. When I slipped it onto the headers there was about a 2cm gap between the end of the slip on and the end of the header connector. Meaning it didn't slip on 100% of the length of the header connector. There's no room for air to get in just curious is this is normal. With the clamp tightened I highly doubt any leaks would occur. If I do slip it on !00% of the length the mounting bolt does not align properly
My previous slipon the Yoshimure RS3 fit the entire length of the connector.
RE: Arrow Slip-on Question - the Ferret - 12-07-2016
you have both pipes, maeasure the length of the connector pipe and see if the arrow is shorter.
RE: Arrow Slip-on Question - holy666diver_imp - 12-07-2016
You know what I think I installed the arrow on the outside of the exhaust bracket instead of the inside... I'll re-install tonight see if that fixes it
Arrow Slip-on Question - holy666diver_imp - 12-07-2016
I installed the arrow exhaust on the back end of the bracket and now the exhaust fully fits. I fully tightened the bolt to the bike and tightened the clamp to the header. There seems to be a little bit of movement now even with the bolts fully tightened. Not enough to do any damage but is a little movement back and forth normal? Anyone with an arrow chime in?
Sent from my iPhone using Tapatalk
RE: Arrow Slip-on Question - holy666diver_imp - 12-08-2016
See the movement? Could this be the clamp to the header is not getting tight enough? I am confused the previous exhaust I had did not move this much.
*MOD you can move this to "mechanical / Technical"
RE: Arrow Slip-on Question - the Ferret - 12-08-2016
it looks like the movement is coming at the peg bracket mounting location to me. Is it rubber mounted?
RE: Arrow Slip-on Question - holy666diver_imp - 12-08-2016
(12-08-2016, 02:00 AM)The ferret_imp Wrote: it looks like the movement is coming at the peg bracket mounting location to me. Is it rubber mounted?
All the stock hardware. Bolt and a rubber grommet inside. It's fully tightened.
RE: Arrow Slip-on Question - the Ferret - 12-08-2016
The reason I asked, at the 14-18 second mark you can clearly see the peg mounting bolt moving up and down as you wiggle the pipe.
RE: Arrow Slip-on Question - holy666diver_imp - 12-08-2016
(12-08-2016, 02:23 AM)The ferret_imp Wrote: The reason I asked, at the 14-18 second mark you can clearly see the peg mounting bolt moving up and down as you wiggle the pipe.
It's as tight as it gets. I'll strip it if I go any tighter. I can try adding another washer see if it tightens up.
RE: Arrow Slip-on Question - the Ferret - 12-08-2016
Or just not worry about it. It's not going to fall off. Does it leak at the joint?