+- The CB1100 Community Forum (https://cb1100forum.net/forum)
+-- Forum: Honda CB1100 Discussions (https://cb1100forum.net/forum/forumdisplay.php?fid=5)
+--- Forum: Accessories/Modifications (https://cb1100forum.net/forum/forumdisplay.php?fid=8)
+--- Thread: Front turn signal mounting hole diameter (/showthread.php?tid=9069)
Front turn signal mounting hole diameter - c-breezy_imp - 04-19-2017
Hoping someone has the answer at hand, and apologies if it's already been covered (I searched) but does anyone know what size mounting bolts the front turn signal mounting holes will accept? I seem to recall that for at least one member, the holes were too small for the aftermarket signals that he purchased and thus, he had to drill.
Thanks in advance!
Front turn signal mounting hole diameter - PowerDubs_imp - 04-19-2017
Dunno, but I can measure stock blinker stems for you- brb.
Sent from my iPhone using Tapatalk
Front turn signal mounting hole diameter - c-breezy_imp - 04-19-2017
That would be great - thanks PowerDubs!
Sent from my iPhone using Tapatalk
Front turn signal mounting hole diameter - PowerDubs_imp - 04-19-2017
The threaded hole for the bolt is about 6mm. There is a locating tab that keeps the blinker from rotating.
Sent from my iPhone using Tapatalk
RE: Front turn signal mounting hole diameter - c-breezy_imp - 04-19-2017
Wow - they are much smaller than I expected. I was considering some turn signals that used 10mm bolts - now I know what to look for!
Thanks again!!!
RE: Front turn signal mounting hole diameter - Lord Popgun - 04-19-2017
In the fiche, the front signal bolt size is 6x10 and the rears 6x14
RE: Front turn signal mounting hole diameter - kennyw - 04-19-2017
The holes on the rear are a lot larger than the bolts. I'm not sure about the fronts.
Front turn signal mounting hole diameter - c-breezy_imp - 04-23-2017
(04-19-2017, 09:46 AM)Lord Popgun_imp Wrote: In the fiche, the front signal bolt size is 6x10 and the rears 6x14
Thanks popgun! Can always count on you for a reference to the manual
![[Image: c846e3a0045d66f41609db49ab924263.png]](https://cb1100forum.net/forum/uploads/imp/201704/c846e3a0045d66f41609db49ab924263.png)
Sent from my iPhone using Tapatalk
Has anyone mounted front turn signals that came with larger diameter mounting bolts in the stock location? I assume you'd just drill them out to be wider?
Sent from my iPhone using Tapatalk