+- The CB1100 Community Forum (https://cb1100forum.net/forum)
+-- Forum: Honda CB1100 Discussions (https://cb1100forum.net/forum/forumdisplay.php?fid=5)
+--- Forum: Accessories/Modifications (https://cb1100forum.net/forum/forumdisplay.php?fid=8)
+--- Thread: Greg, here's the Yoshi Badge (/showthread.php?tid=10221)
Greg, here's the Yoshi Badge - CIP57_imp - 06-26-2014
Just received them from Thailand, took a month
If you buy them roll the badge with your finger on a piece of PVC to get a bit of a curve, that's #2 on there, the first one i could not get to seal properly.
[url=http://s1034.photobucket.com/user/cipolla57/media/photo_zpsff37850c.jpg.html]
![[Image: 3bc94e5477e1d56115610a85b58c266c.jpg]](https://cb1100forum.net/forum/uploads/imp/201406/3bc94e5477e1d56115610a85b58c266c.jpg)
Greg, here's the Yoshi Badge - Ridem32_imp - 06-26-2014
Looks good! Those valve stem caps look pretty good also.
RE: Greg, here's the Yoshi Badge - CIP57_imp - 06-26-2014
(06-26-2014, 05:36 AM)Ridem32_imp Wrote: Looks good! Those valve stem caps look pretty good also.
RE: Greg, here's the Yoshi Badge - Greg_imp - 06-26-2014
Are they plastic? Metal? Looks good. I'll PM you for the cost details.
I'm still nervous about taking off the factory badge. I have the hand-bent pipes which are slightly more matte than yours. The badge appears to be aluminum and it's fastened on there good; must be heat resistant adhesive too?
RE: Greg, here's the Yoshi Badge - CIP57_imp - 06-26-2014
(06-26-2014, 10:03 AM)Greg_imp Wrote: Are they plastic? Metal? Looks good. I'll PM you for the cost details.
I'm still nervous about taking off the factory badge. I have the hand-bent pipes which are slightly more matte than yours. The badge appears to be aluminum and it's fastened on there good; must be heat resistant adhesive too?
The badge comes off clean than use rubbing alcohol to clean any residue.
There the same material as the larger badge. I order 1 than 3 more. I received the package of three today. They have plastic protective film on the outside, don't forget to peel it off. As long as you roll it a bit to get a similar contour of the pipe before install your fine. There only a couple dollars no worries, I'll PM you for your address.