+- The CB1100 Community Forum (https://cb1100forum.net/forum)
+-- Forum: Honda CB1100 Discussions (https://cb1100forum.net/forum/forumdisplay.php?fid=5)
+--- Forum: General Discussion (https://cb1100forum.net/forum/forumdisplay.php?fid=6)
+--- Thread: Trouble starting my CB when I when I use the on/ off button to shut of My CB. I (/showthread.php?tid=582)
RE: Trouble starting my CB when I when I use the on/ off button to shut of My CB. I - pdedse - 08-03-2021
(08-03-2021, 01:45 AM)Lord Popgun_imp Wrote: Your CB1100 also has what Honda calls a Bank Angle Sensor
Haha...didn't know that! Next thing you'll tell me is that the term Bank Angle Sensor is a common term among the mc community and my not knowing is...telling.
So if my BAS shuts my bike off should it decide to take a nap, why would the bike need a kill switch?
RE: Trouble starting my CB when I when I use the on/ off button to shut of My CB. I - Cormanus - 08-03-2021
So you can turn it off accidentally when you’re riding along in the middle of nowhere and have a moment or two’s panic about why the bike has stopped before realizing what you’ve done. Don’t ask how I know.
RE: Trouble starting my CB when I when I use the on/ off button to shut of My CB. I - max - 08-04-2021
Nice one Cormanus, never thought of it like that but it sticks
The red stop switch removes 12 volts from the e.c.u. and the e.c.u. has to go through it's brief startup cycle before the engine is ready to run again.
The bank angle sensor is hard wired to the ground side of the engine stop relay ( which controls the engine 12 volt bus supplying all relevant equipment to run the engine ) it has ( thoughtfully ) nothing to do with the e.c.u. and therefore no logic has to make decisions in the process, i'm picking it is a weight with a switch attached that stays in place as long as the g force of the bike points straight down the centerline, but if the bike is not moving and falls beyond the setpoint of the b.a.sensor it breaks the contact, disengages the engine stop relay and thereby removes the 12 v. supply to the engine 12v bus ( the engine stops ).
This simplified diagram may explain this;
RE: Trouble starting my CB when I when I use the on/ off button to shut of My CB. I - Lord Popgun - 08-04-2021
Thanks Max! Now I don’t have to look it up
RE: Trouble starting my CB when I when I use the on/ off button to shut of My CB. I - Cormanus - 08-04-2021
Aye. He’s a good man, our Max.
RE: Trouble starting my CB when I when I use the on/ off button to shut of My CB. I - GoldOxide_imp - 08-04-2021
That's cool max - thanks.
RE: Trouble starting my CB when I when I use the on/ off button to shut of My CB. I - Rox_imp - 08-04-2021
Just get a new switch..