+- The CB1100 Community Forum (https://cb1100forum.net/forum)
+-- Forum: Honda CB1100 Discussions (https://cb1100forum.net/forum/forumdisplay.php?fid=5)
+--- Forum: Accessories/Modifications (https://cb1100forum.net/forum/forumdisplay.php?fid=8)
+--- Thread: Bar end weight replacement (/showthread.php?tid=8604)
Pages:
1
2
RE: Bar end weight replacement - Gone in 60 - 04-12-2019
(04-12-2019, 08:32 AM)Houtman_imp Wrote: I put an right sized O ring in the gaps to make it look better and still be able to turn the throttle freely , same on the clutch side .
That's a good idea. I'm coming back to Honda after a string of BMWs. Everything is built to millimetric tolerance. But, everything is very, very expensive.
RE: Bar end weight replacement - GoldOxide_imp - 04-12-2019
(04-12-2019, 08:41 AM)Gone in 60_imp Wrote:(04-12-2019, 08:32 AM)Houtman_imp Wrote: I put an right sized O ring in the gaps to make it look better and still be able to turn the throttle freely , same on the clutch side .
That's a good idea. I'm coming back to Honda after a string of BMWs. Everything is built to millimetric tolerance. But, everything is very, very expensive.
That's a good idea. I'm coming back to Honda after a string of BMWs. Everything is built to millimetric tolerance. But, everything is very, very expensive.
Das auto.
RE: Bar end weight replacement - Gone in 60 - 04-12-2019
And you can work on your own Honda without being cast out with the unwashed and stoned to death.