+- The CB1100 Community Forum (https://cb1100forum.net/forum)
+-- Forum: Honda CB1100 Discussions (https://cb1100forum.net/forum/forumdisplay.php?fid=5)
+--- Forum: General Discussion (https://cb1100forum.net/forum/forumdisplay.php?fid=6)
+--- Thread: Sorry Guys Exhaust question again (/showthread.php?tid=842)
Pages:
1
2
RE: Sorry Guys Exhaust question again - Newceebee_imp - 06-26-2020
I've got a '13 cast-wheel model fitted with an Arrow end can and it sounds very good without being obtrusive - lighter than the original too.
RE: Sorry Guys Exhaust question again - jedd_imp - 06-29-2020
(06-25-2020, 11:46 PM)Adventure boy_imp Wrote: beardyweirdy Ive PMd you re the above
I also drilled the first plate baffle out it had three little 1/4 holes in it ive drilled that right out with an inch bit it sounds a lot nicer now but would still prefer a 4 into 1
Rob
here's a pic of the cross section of the 2017-2019 muffler (top pic) vs. 2013-2014. There's a better chance of success w/ the 2017 b/c there's one less partition.
![[Image: 54e605038f54cfc519c01dbd7e723004.jpg]](https://cb1100forum.net/forum/uploads/imp/202006/54e605038f54cfc519c01dbd7e723004.jpg)
also, re: 4:1 off the 2013-2014, you would need to use the rear foot peg bars of the same year b/c the muffler hanger is located much closer to the rr pegs vs. the 2017.
RE: Sorry Guys Exhaust question again - Adventure boy_imp - 07-06-2020
Cheers guys
I think it now sounds very nice so will leave it for now, iv a 4 into one comes up ill have it
Rob