+- The CB1100 Community Forum (https://cb1100forum.net/forum)
+-- Forum: Honda CB1100 Discussions (https://cb1100forum.net/forum/forumdisplay.php?fid=5)
+--- Forum: General Discussion (https://cb1100forum.net/forum/forumdisplay.php?fid=6)
+--- Thread: Seat cushion, custom padding, horn placement (/showthread.php?tid=672)
Pages:
1
2
RE: Seat cushion, custom padding, horn placement - bflint - 03-11-2021
Have to give my custom Corbin two thumbs up for comfort and looks. After 50K+ miles, had to send it back to Corbin last week to have leather cover replaced. There was not tears/rips, but the left side that I mount from was starting to show some white underlayment so it was time to make it perfect again
RE: Seat cushion, custom padding, horn placement - Whoops - 04-08-2021
(03-07-2021, 06:18 AM)max_imp Wrote: Installed a removable time delay on my cb1000r, horn activates 0.5 sec. after the button is pushed,
the button is pushed, the resistor charges the capacitor over time, voltage rises to the point it is enough to attract the relay, the contacts close and the horn sounds;
It worked, no more accidental horn, the buttons on the cb1000r were reversed from the other Honda models i own, it became an annoyance, technology to the rescue.
Parts; small relay, 2200uf capacitor and 100 or so ohm resistor, done.
You need to build a little plug and play device and sell these!
