The CB1100 Community Forum

Did anyone notice Ole's set-up ? He had a foam pad on top of the seat covered with a black furry thing, looked very comfy..

(06-15-2015, 09:07 AM)StreetFighter_imp Wrote: [ -> ]

(06-14-2015, 03:14 PM)Pterodactyl_imp Wrote: [ -> ]For a multi-day ride I use an Airhawk. Day rides, even big days, OEM suits. I'm not fussed about changing the seat. But Cick design is looking more attractive for day rides. It has some carrying capacity and I like the look. Each to his own i guess.

Cheers

What's an Airhawk?

(06-15-2015, 04:52 AM)ChipBeck_imp Wrote: [ -> ]

(06-14-2015, 11:40 PM)The ferret_imp Wrote: [ -> ]also might consider the Chip Beck spec Corbin

http://cb1100forum.com/forum/showthread....=Chip+Beck

Gentlemen,

Last week I tried all three of my seats again. A K&H mid seat, the stock seat, and my Chip Beck Spec Corbin. After 3 half hour rides with each seat the choice was again obvious. Corbin is the most comfortable seat for both rider and passenger. Renea prefers it and so do I by a big margin. I can ride 3 hour freeway legs with it. I normally sit up toward the tank and I slide back into the Corbin's wide rear depression at freeway speeds when I want to lean forward more into the wind.

Chip

Gentlemen,

Last week I tried all three of my seats again. A K&H mid seat, the stock seat, and my Chip Beck Spec Corbin. After 3 half hour rides with each seat the choice was again obvious. Corbin is the most comfortable seat for both rider and passenger. Renea prefers it and so do I by a big margin. I can ride 3 hour freeway legs with it. I normally sit up toward the tank and I slide back into the Corbin's wide rear depression at freeway speeds when I want to lean forward more into the wind.

Chip
It's the same seat right? Just a different stayling to it.

(06-14-2015, 11:11 PM)metalmaven_imp Wrote: [ -> ]

what wind screen is that?

what wind screen is that?
[/quote]

That is a DART Fly Screen. Been looking at windshields too!

Sorry, didn't realize he already answered you.
[/quote]
Yes it's the same Corbin CB1100 seat without tuck & roll stitching, no welts, and no back rest accommodations.

Chip

In other words its the same Corbin seat which is made to look as close to the stock one as possible. Corbin quality and comfort with he cb1100 classic stock look.

Streetfighter, here is a link to the Airhawk distributor: http://www.motorcyclecushions.net/collec...on-cruiser

Ok, that link goes to the small pillion page, but there you go. The small pillion Airhawk will fit nicely on the front or our seats. I use that. Works good if you have a smaller butt. Don't blow them up too much. Less is better.

There are some on here that have a regular style and I use one of those on the ST. Both mine are Airhawk II models.

Got my Corbin seat in today...... Stupid Tropical Storm Bill....

Still may ride to a friend's house a couple of miles away, just to try it out.

Bill won't last forever


Sent from my iPad using Tapatalk