The CB1100 Community Forum

I found this bracket while doing my own custom relocation. It would require two holes to be drilled to bolt to the fender. I have not used it myself but thought someone else may like it.

http://www.kuryakyn.com/products/3908/li...ght-mounts

Why couldnt you bolt that to the lic plate bracket and not have to drill any holes?

(07-30-2016, 07:58 AM)The ferret_imp Wrote: [ -> ]Why couldnt you bolt that to the lic plate bracket and not have to drill any holes?

The photo above shows the two central counter sunk holes that would need to be drilled in order to mount to the licence plate bracket attached to the fender. And, if the spacing is similar to mine, you might also need to add a couple of thick washers behind the drilled holes, so that the new plate does not touch the fender at the bottom.

Ahh gotcha.