The CB1100 Community Forum

Got a quick video of the exh before work

Sent from my VS985 4G using Tapatalk

Yeah, my eliminator cost $275 and the signals another $150, but I love the look:

Mine will look the same. IF/WHEN I finish it

Hahah

Got it cut and did some rolling. Think I'll measure up, cut and dry fit this weekend.

(04-22-2016, 10:06 AM)gbpack89_imp Wrote: [ -> ]Got a quick video of the exh before work

Sent from my VS985 4G using Tapatalk

Holy crap that sounds mean! My neighbors would kill me. I like it though, LOL

Haha I went in to grab my jacket and the wife asked what it was I was doing out there 😀

Sent from my VS985 4G using Tapatalk

(04-12-2016, 02:16 AM)gbpack89_imp Wrote: [ -> ]Yeah, just cut it after the hole for the tail light wiring. I still wanted to use it for the new wires



Sent from my VS985 4G using Tapatalk

What type of saw/blade did you use to cut it?

I recently eliminated my rear fender and installed a LED tail/brake light. I can't get the running lights to work, it's 3 wires but it won't work. I can get the brake light to work only when grounding the black wire to the chassis and not the original black wire from the harness.

any suggestions?

Ken, On our bike, the wiring harness ground wires are green. Unless someone helps you, when I get off work I'll check the wiring diagram for the taillight colors. Not that there are reports of swapped wires on some 14's.

(04-23-2016, 01:54 AM)0011bc_imp Wrote: [ -> ]Got it cut and did some rolling. Think I'll measure up, cut and dry fit this weekend.

Are you thinking of re-enforcing the sheetmetal? Maybe a couple of 3/8" tubing pieces, bent to the contour, and welded in place? The tubing could serve as a conduit for the wiring if needed.

Just a thought. Thanks for sharing.