Just installed the Superbrace & want to retorque the axle pinch bolts. I guessed at 25 #, but would like something more accurate than my guess. Thanks, Rocket
When I installed my Superbrace, I referenced the ferret's thread on how to install fork gaiters for the pinch bolt torque measurements (19 ft lbs). I finally broke down and ordered the service manual yesterday but knowing how detailed the ferret is in his calculations, I have no doubt that it's spot on.
His thread is here:
http://cb1100forum.com/forum/showthread.php?tid=3289 In post #3, he lists the torque values at the end.
Honda service manual says 17flbs for the upper triple clamp bolts and 32flbs for the lower.
19flbs for the pinch bolts.
(03-16-2015, 06:48 AM)redbirds_imp Wrote: [ -> ]Honda service manual says 17flbs for the upper triple clamp bolts and 32flbs for the lower.
19flbs for the pinch bolts.
I will NEVER trust the ferret AGAIN.
Am I correct in assuming the "clamp bolts" are the same as the "pinch bolts"?
(03-16-2015, 06:51 AM)metallyguitarded_imp Wrote: [ -> ] (03-16-2015, 06:48 AM)redbirds_imp Wrote: [ -> ]Honda service manual says 17flbs for the upper triple clamp bolts and 32flbs for the lower.
19flbs for the pinch bolts.
I will NEVER trust the ferret AGAIN.
Am I correct in assuming the "clamp bolts" are the same as the "pinch bolts"?
I will NEVER trust the ferret AGAIN.
Am I correct in assuming the "clamp bolts" are the same as the "pinch bolts"?
You were right the first time. I screwed up and listed the triple clamp values then corrected my mistake and listed the values for the pinch bolts.
(03-16-2015, 06:55 AM)redbirds_imp Wrote: [ -> ] (03-16-2015, 06:51 AM)metallyguitarded_imp Wrote: [ -> ] (03-16-2015, 06:48 AM)redbirds_imp Wrote: [ -> ]Honda service manual says 17flbs for the upper triple clamp bolts and 32flbs for the lower.
19flbs for the pinch bolts.
I will NEVER trust the ferret AGAIN.
Am I correct in assuming the "clamp bolts" are the same as the "pinch bolts"?
I will NEVER trust the ferret AGAIN.
Am I correct in assuming the "clamp bolts" are the same as the "pinch bolts"?
You were right the first time. I screwed up and listed the triple clamp values then corrected my mistake and listed the values for the pinch bolts.
I will NEVER trust the ferret AGAIN.
Am I correct in assuming the "clamp bolts" are the same as the "pinch bolts"?
You were right the first time. I screwed up and listed the triple clamp values then corrected my mistake and listed the values for the pinch bolts.
Like I said, I never, ever, doubt the ferret.
Dang you guys had me confused for a minute.
I'm still not sure if I posted it right or wrong. guess it depends on what you are labeling pinch bolts. I would think those would be the two little ones down by the axle on the front of the lower legs.
Thanks for the help.
Ferret: Yes the AXLE pinch bolts.