Was cleaning the bike and found that the little cable that goes to the wheel speed sensor was not connected correctly. The little clip for the cable appears to be broken. Can anyone share a pic of a good one? Zip tied for now.
[url=http://s126.photobucket.com/user/cwwskw/media/e913ebc4-314b-4805-ae96-78a2bd8578a6_zpswvwgg0xj.jpg.html]
![[Image: f93458eeaeb895c12ab3397c1352b66e.jpg]](https://cb1100forum.net/forum/uploads/imp/201707/f93458eeaeb895c12ab3397c1352b66e.jpg)
(07-07-2017, 09:41 AM)TwoBrothersBusa_imp Wrote: [ -> ]Was cleaning the bike and found that the little cable that goes to the wheel speed sensor was not connected correctly. The little clip for the cable appears to be broken. Can anyone share a pic of a good one? Zip tied for now.
[url=http://s126.photobucket.com/user/cwwskw/media/e913ebc4-314b-4805-ae96-78a2bd8578a6_zpswvwgg0xj.jpg.html]
Here is a shot of mine. It's a double snap piece of plastic. You should be ready to go with the cable tie. By the way, mine was not snapped on the break line. Thanks for the heads up!
Sent from my SM-T710 using Tapatalk
Thanks for the snapshot! The things that zip ties have done for me over the years...
You guys just made me go look at mine. It is installed on the brake line ok, but twobros, yours is backwards compared to my '13.
Mine looks like Retsel's, except it is seated on the brake line. IOW, it snaps on from the outside. The service manual may show it, I'll have to check.
In looking at the clip, its plastic and I think may get hard and be easy to break in the future. I may order a spare for later.
Looked at mine. it comes up from the bottom with open end for wire on top