The CB1100 Community Forum

I need oil bolt torque for front caliper/master cylinder

Oh and fork preload adjuster too.

Many thanks!!

If you mean the Brake Caliper Bleed valve, it is 4 ft lbs. Same for front and back.

I think you want the fork bolt (manual reference). The torque is 16 ft lbs. And the manual says to use a new o-ring if the assembly is removed and to oil it with fork oil. YMMV.

Popgun, you were faster this time

(10-20-2018, 01:36 AM)peterbaron_imp Wrote: [ -> ]Popgun, you were faster this time

I was surprised you had not answered it before I did.

(10-20-2018, 01:47 AM)Lord Popgun_imp Wrote: [ -> ]

(10-20-2018, 01:36 AM)peterbaron_imp Wrote: [ -> ]Popgun, you were faster this time

I was surprised you had not answered it before I did.

I was surprised you had not answered it before I did.
Yeah, well it took him 47 minutes to answer!

Thanks all. I was putting on some braided brake lines, they called the bolt on the end of each line connecting to calipers and MC as "Oil line" I found the torque spec on the website.

I torqued the fork caps by "feel". Now I have nice bling gold caps to distract me. (not on my teeth)

Sorry about that HBFL. Peter or I would have been happy to list the torque but wasn’t sure what you wanted and thought you were maybe bleeding the brakes.

Just ask, we’ll get it to ya!

(10-23-2018, 08:24 AM)Lord Popgun_imp Wrote: [ -> ]Sorry about that HBFL. Peter or I would have been happy to list the torque but wasn’t sure what you wanted and thought you were maybe bleeding the brakes.

Just ask, we’ll get it to ya!

Popgun, slow down and thanks for the recommendations

No sweat folks!