The CB1100 Community Forum

I'd be there in a heartbeat if I was closer.

I'd love to see a DLX in real life.

I'd love to see & hear the pipemasters in real life.

I'd love to go to Sierra Nevada!

(05-13-2021, 01:36 AM)PowerDubs_imp Wrote: [ -> ]I'd be there in a heartbeat if I was closer.

I'd love to see a DLX in real life.

I'd love to see & hear the pipemasters in real life.

I'd love to go to Sierra Nevada!

I just had a call from Amos , he is planning to come the first week in June as both of us are away before that . Come and join us and I buy you lunch too !

Hmm, either I am deaf or Houtman hasn't installed yet his Pipe Master exhaust set ????

Look at the post above yours, peterbaron.

(05-25-2021, 08:37 PM)Cormanus_imp Wrote: [ -> ]Look at the post above yours, peterbaron.

Ha, ha, ha,
The only excuse I have is....because I was thinking about your birthday today

I love those pipes...want some real bad

First week in June. Excited.


Sent from my iPhone using Tapatalk

Amos will come to our house on Monday June 7 to help with putting the pipes on , The headers I put on a while ago but it will be easier to have a person on each side to install cross over part and pipes. On the CBX it was very easy to install the six into six as it was just two separate 3 pipe sets with no cross over.

When you do, if you could please take a picture of where the o2 sensors are- especially in regards of clearance with the frame.


Sent from my iPhone using Tapatalk

(06-03-2021, 01:04 PM)PowerDubs_imp Wrote: [ -> ]When you do, if you could please take a picture of where the o2 sensors are- especially in regards of clearance with the frame.


Sent from my iPhone using Tapatalk

The two O2 sensor connectors are on the cross over section , I have blocked them of as I use the O2 sensor eliminators on my 2014 and have for a while to see how it would run without them : perfect ! Picture will follow when Amos is here or if you pm your email address we can send it now.