I didn’t get it done as I had some other things to do. But I did start. Got the shelf rail and cut it to size then started drilling the holes. Man, what a J.O.B. That is some good metal and I’m using a hand drill. Got one and a half holes done. So 2 and a half more to go!
Can you drill half a hole?
(11-14-2022, 10:21 PM)GoldOxide_imp Wrote: [ -> ] (11-14-2022, 10:17 PM)Cormanus_imp Wrote: [ -> ]Can you drill half a hole?
Good one Cormanus. lol
Good one Cormanus. lol
You can get half holes from Amazon in inch and metric sizes, but they will take a while to get because they are shipped from China, and you have to buy them in bags of 100. Only problem is, you have to drill a hole all the way through, then insert these half-hole plugs that block half the whole hole rather than the whole half hole.
This thread has gone from vast to half-vast.
(11-15-2022, 03:54 AM)Nachodaddy_imp Wrote: [ -> ]This thread has gone from vast to half-vast.
Yeah, 'cos of half a hole issue...
So, what is the best cutting oil to use? Heh Heh, now it’s an OIL thread
lol - our daily dose of Forum humour I see.
(11-15-2022, 06:13 AM)Lord Popgun_imp Wrote: [ -> ]So, what is the best cutting oil to use? Heh Heh, now it’s an OIL thread
MiLord, the best OIL for drilling holes or half a hole is used Motul 10W40 synthec drained from my bikes.
For half a hole drilling, you must follow a special procedure.