Just received them from Thailand, took a month
If you buy them roll the badge with your finger on a piece of PVC to get a bit of a curve, that's #2 on there, the first one i could not get to seal properly.
[url=http://s1034.photobucket.com/user/cipolla57/media/photo_zpsff37850c.jpg.html]
![[Image: 3bc94e5477e1d56115610a85b58c266c.jpg]](https://cb1100forum.net/forum/uploads/imp/201406/3bc94e5477e1d56115610a85b58c266c.jpg)
Looks good! Those valve stem caps look pretty good also.
Are they plastic? Metal? Looks good. I'll PM you for the cost details.
I'm still nervous about taking off the factory badge. I have the hand-bent pipes which are slightly more matte than yours. The badge appears to be aluminum and it's fastened on there good; must be heat resistant adhesive too?
(06-26-2014, 10:03 AM)Greg_imp Wrote: [ -> ]Are they plastic? Metal? Looks good. I'll PM you for the cost details.
I'm still nervous about taking off the factory badge. I have the hand-bent pipes which are slightly more matte than yours. The badge appears to be aluminum and it's fastened on there good; must be heat resistant adhesive too?
The badge comes off clean than use rubbing alcohol to clean any residue.
There the same material as the larger badge. I order 1 than 3 more. I received the package of three today. They have plastic protective film on the outside, don't forget to peel it off. As long as you roll it a bit to get a similar contour of the pipe before install your fine. There only a couple dollars no worries, I'll PM you for your address.
