The CB1100 Community Forum

Now that is a question. Inline with the rail or parallel to the deck... Hmmm

Still looks good though! Mighty good! Now to test with some bags to see if they are clear of the bags

Sent from my XT1055 using Tapatalk

Closer and closer. Final tweaks. Then production


Sent from my iPad using Tapatalk

Lookin mighty good. Any estimate on cost yet?

Sent from my XT1055 using Tapatalk

None.
Have to maybe post a thread later and see what quantity would be in relation to cost


Sent from my iPad using Tapatalk

Lovely job.

I'm in!!

Will our stock lights fit? Sorry if thats been asked...

It was being designed to accommodate the stock signals but I believe an electrical harness extension would be required.

Sent from my XT1055 using Tapatalk

(04-22-2014, 10:23 PM)dBuster_imp Wrote: [ -> ]It was being designed to accommodate the stock signals but I believe an electrical harness extension would be required.

Sent from my XT1055 using Tapatalk

dbuster,

Great! I'm an electronics tech so wiring it or getting an extension as shown above somewhere is no biggie.

Thanks.

There will need to be a wire extension. No biggie for most people to handle. The wire will run through the chase shown as to be clean of wires


Sent from my iPhone using Tapatalk

(04-23-2014, 12:23 AM)Lord Popgun_imp Wrote: [ -> ]

(04-22-2014, 10:23 PM)dBuster_imp Wrote: [ -> ]It was being designed to accommodate the stock signals but I believe an electrical harness extension would be required.

Sent from my XT1055 using Tapatalk

dbuster,

Great! I'm an electronics tech so wiring it or getting an extension as shown above somewhere is no biggie.

Thanks.

Are you going to be making the extension harnesses to go along with this wonderful fabrication work?

Was just pointing out that it would work with our stock signals but you were on your own for the harness extensions. Basically I answered your original question I thought...



Sent from my XT1055 using Tapatalk