06-10-2020, 11:48 PM
I replaced the way-too-short sidestand on my '14 STD with the part from the '17 model. The lean angle is much improved.
I noticed while doing the replacement that the gap at the top of both side stands was noticeably wider than it needs to be to fit over the frame mounting plate. There is almost 1mm of play there. I checked few other Honda models and found the same thing. My old 2005 VFR800 is the same way.
Does anyone know the reason for the built-in slop in that hinge? I'm tempted to put a washer in the gap.
I noticed while doing the replacement that the gap at the top of both side stands was noticeably wider than it needs to be to fit over the frame mounting plate. There is almost 1mm of play there. I checked few other Honda models and found the same thing. My old 2005 VFR800 is the same way.
Does anyone know the reason for the built-in slop in that hinge? I'm tempted to put a washer in the gap.