04-24-2021, 04:35 AM
so...if you do the PULL DOWN THEN PUSH UP method of checking slack and adjust to to say 1 1/8" of total slack using THAT method (between pin when pulled down and same pin when pushed up)
would you have MORE .... or less SLACK ... if adjusting it to 1 1/8" slack using only the PUSH UP method ? (between pin with chain at natural hang and same pin when pushed up)
There would be 8mm (3/10ths inch) of difference between the two right? (that's pretty negligible)
would you have MORE .... or less SLACK ... if adjusting it to 1 1/8" slack using only the PUSH UP method ? (between pin with chain at natural hang and same pin when pushed up)
There would be 8mm (3/10ths inch) of difference between the two right? (that's pretty negligible)
