04-22-2021, 02:48 AM
I have always gone to the middle of the bottom of the chain.
Put a ruler or tape measure behind it. And give it a gentle wiggle both Up & Down and make sure it falls within the margin.
If it would move 1 inch upwards from baseline, then it would also move 1 inch below baseline (downwards). And that would give you a total slack of 2 inches instead of 1 inch in 1 direction.
This is the way I learned (but it can be wrong and im open to hearing otherwise)
Sent from my SM-G965U1 using Tapatalk
Put a ruler or tape measure behind it. And give it a gentle wiggle both Up & Down and make sure it falls within the margin.
If it would move 1 inch upwards from baseline, then it would also move 1 inch below baseline (downwards). And that would give you a total slack of 2 inches instead of 1 inch in 1 direction.
This is the way I learned (but it can be wrong and im open to hearing otherwise)
Sent from my SM-G965U1 using Tapatalk