05-09-2021, 06:38 AM
Couple more questions for this post as I research and am ready to start ordering some part, I don't want to keep opening up new ones. So hope this is fine.
Not ideal, but I think I have decided to get an electronic speedo/tach cluster. Kind of like this, just haven't really found the "right" one. Does anyone have experience with replacing these? Or can anyone point me into something similar that won't need much additional setup. Figure go a bit cheaper and if I don't like the look then I can go back to oem. Just a bit rough to drop $1,100-$1,300 on it.
https://www.motosport.com/koso-db03r-mul...ge?variant[KSO000F]=KSO000F-X001-Y001
I was looking at my handlebar replacement and went out to take some measurements. I had a bar end on the throttle side that was bent so I pulled it off and realized that the throttle was not smooth. Figured it was due to the bent bar end. I'm going to pull off the grip and all tomorrow to see if it's still not smooth. I had crash bars so I'm assuming nothing inside would have been damaged to cause that? Just looking for guidance on where to follow if it doesn't end up being the something on the handlebar that is causing that.
I can't thank everyone enough for all the help!
Not ideal, but I think I have decided to get an electronic speedo/tach cluster. Kind of like this, just haven't really found the "right" one. Does anyone have experience with replacing these? Or can anyone point me into something similar that won't need much additional setup. Figure go a bit cheaper and if I don't like the look then I can go back to oem. Just a bit rough to drop $1,100-$1,300 on it.
https://www.motosport.com/koso-db03r-mul...ge?variant[KSO000F]=KSO000F-X001-Y001
I was looking at my handlebar replacement and went out to take some measurements. I had a bar end on the throttle side that was bent so I pulled it off and realized that the throttle was not smooth. Figured it was due to the bent bar end. I'm going to pull off the grip and all tomorrow to see if it's still not smooth. I had crash bars so I'm assuming nothing inside would have been damaged to cause that? Just looking for guidance on where to follow if it doesn't end up being the something on the handlebar that is causing that.
I can't thank everyone enough for all the help!