11-08-2022, 12:28 PM
(11-08-2022, 10:00 AM)norton1974_imp Wrote: Hello, the oil pressure wire checks out from switch to plug.
what supplies the power for light ?
White connector shows 6wire white plug.
However only 5 wires are used.
One is blocked with a plug
Wireing diagram shows green ground wire
That is not present.
Any thoughts?
Thanks for your time
Gr
White 6-pin connector only uses 5 of the pins. Green ground wire goes to the gray 8-pin connector, so not likely a problem. There is a sub-harness that the 3 plugs in the headlight lead to, but you will have to take the meter off the bike and put it onto a table to work with. Then you can test continuity on the dark-blue/red wire trough this sub-harness. if it's good, plug the white sub-harness connector into the connector in the headlight, and check that wire to ground. If it's got continuity, then it looks like the LED may be bad, which is very rare.