07-02-2017, 02:50 AM
I don't remember it being a problem when I adjusted mine (in 2013). Tighten one, then do the other. You may have to hold the ball joint. Can't remember, but it wasn't a problem.
How tight? Well, good and snug. But since you asked. When no torque value is specified, you use the Standard Torque Values table. In the '13 manual it is on page 1-9. In the '14 manual it is on page 1-12 at the top.
How tight? Well, good and snug. But since you asked. When no torque value is specified, you use the Standard Torque Values table. In the '13 manual it is on page 1-9. In the '14 manual it is on page 1-12 at the top.