Double stack- hold the cheese

[1973cb750]

Why would you want to buy something that does not work?

These made only the slightest gain over what the stock velocity stacks make once you bore them out.


To remove the stock velocity Stacks all you need to do is take the back half off the airbox.

To install these you need to remove the entire airbox and the entire throttlebody assembly from the cylinder head. You then need to modify the front half of the airbox to fit these in as they are larger. A whole lot more work for no benefit.

I already have a bigger camshafts.


Sent from my iPhone using Tapatalk

I wana keep my stock parts stock its ok ill figure it out on my own thanks for the help

Still like to get a set of those

Nope. I can save you much time and aggravation.

Unless you like just a smidge more than what my ‘free’ homemade bored out factory Honda velocity stacks made.

104whp has been achieved.

Was it worth all the time and effort? No.








Sent from my iPhone using Tapatalk

Nope. I can save you much time and aggravation.

Unless you like just a smidge more than what my ‘free’ homemade bored out factory Honda velocity stacks made.

104whp has been achieved.

Was it worth all the time and effort? No.








Sent from my iPhone using Tapatalk


What i was after was just a few ponies not looking to make a max effort of the 1100 mine still has the speed limiter anyways a few hours work and 3 hp would make me happy after all if i wanted to go to the highest possible the head would be on my bench and a set of higher compression custom pistons would be on order and a die grinder