12-26-2020, 08:25 AM
(12-25-2020, 06:59 AM)Tev62_imp Wrote:(12-25-2020, 06:24 AM)Alain Lee_imp Wrote:(12-25-2020, 12:43 AM)Tev62_imp Wrote:(12-23-2020, 09:19 PM)Lord Popgun_imp Wrote: There is a switched accessory connector in the headlight shell and in the location you found.
Do you know what current they are rated at and what fused circuit they come off by any chance?
Do you know what current they are rated at and what fused circuit they come off by any chance?
Since LP is busy by the fireplace waiting for Santa to drop down by the chimney to deliver his new toy, please allow me to give you the required info for the power.
The "option" power is supplied via a 10A "OP" fuse or "K" designation in the Honda wiring.
Inside the headlight bucket the 2-pin dummy connector wire colour is "Black/Brown" for +12v and "Green" for ground and the same colour applies for the 4-Pin Dummy connector behind the left side cover.
Note: The 4-pin connector has 2 other wires; One is for the OBD2 communication wire.
Regards
Alain
Do you know what current they are rated at and what fused circuit they come off by any chance?
Since LP is busy by the fireplace waiting for Santa to drop down by the chimney to deliver his new toy, please allow me to give you the required info for the power.
The "option" power is supplied via a 10A "OP" fuse or "K" designation in the Honda wiring.
Inside the headlight bucket the 2-pin dummy connector wire colour is "Black/Brown" for +12v and "Green" for ground and the same colour applies for the 4-Pin Dummy connector behind the left side cover.
Note: The 4-pin connector has 2 other wires; One is for the OBD2 communication wire.
Regards
Alain
Alain, you are very kind, much obliged.
Do you know what current they are rated at and what fused circuit they come off by any chance?
Since LP is busy by the fireplace waiting for Santa to drop down by the chimney to deliver his new toy, please allow me to give you the required info for the power.
The "option" power is supplied via a 10A "OP" fuse or "K" designation in the Honda wiring.
Inside the headlight bucket the 2-pin dummy connector wire colour is "Black/Brown" for +12v and "Green" for ground and the same colour applies for the 4-Pin Dummy connector behind the left side cover.
Note: The 4-pin connector has 2 other wires; One is for the OBD2 communication wire.
Regards
Alain
Alain, you are very kind, much obliged.
I forgot to mention that one can purchase the headlight bucket 2-Pin connector male/female from the internet. -
Check this tread. http://cb1100forum.com/forum/showthread....torRegards
Alain