12-23-2020, 08:45 PM
I am going to add some small bullet LED's to the engine bars on my 2018EX to increase other road users visibility of me. They will be always on so I don't need a handlebar switch which will save on wiring runs. I will power them off a relay which will be switched from a 12v source only on ignition. I was about to ask the forum for the best location of the switched live but thought I would do some investigating first.
Under the left hand side panel there were two wires marked "switched live for accessories". Well that was quick, thankyou previous owner and/or the dealer! That saved me a load of hassle and is in a good spot for my relay and cable runs. These cables come out of the Honda 4-way Sumitomo block which I take everyone has? I just don't know if these two cables are standard or have been added by someone else, they look factory.
Right, off to by a four way automotive relay with a Diode.
Under the left hand side panel there were two wires marked "switched live for accessories". Well that was quick, thankyou previous owner and/or the dealer! That saved me a load of hassle and is in a good spot for my relay and cable runs. These cables come out of the Honda 4-way Sumitomo block which I take everyone has? I just don't know if these two cables are standard or have been added by someone else, they look factory.
Right, off to by a four way automotive relay with a Diode.