06-17-2022, 09:16 AM
Yesterday i bought two 330 ohm resistors, unplugged the iacv and installed them in the iacv connector;
and put insulation tape around them to keep things in place;
Before i did this i had switched the cb off when coming back from a ride so the engine idled at 1050.
Lifted the tank, removed the plastic panel and disconnected the iacv ( in the 1050 rpm position )
Then went for a short ride with the resistors installed and all went well, engine drove as usual, no change.
This morning the engine was cold when i started the bike and this was the result;
https://www.youtube.com/watch?v=lVhFQ7VpHMY
There are several other options, one example is having a two way switch change from having the iacv immobilized with the resistors or having it operate normally, this requires ;
A double pole 2 way switch, the two resistors and two connectors, one male and one female 4 pole connector.
That way it is very simple to alter the position of the iacv when the situation changes ( colder weather )
If this worked for me it may work for you, cost; 1 dollar for the two 1 watt 330 ohm resistors, what is importand is the diameter of the resistor leads which is 0,7 mm. so they fit correctly in the female connector.
and put insulation tape around them to keep things in place;
Before i did this i had switched the cb off when coming back from a ride so the engine idled at 1050.
Lifted the tank, removed the plastic panel and disconnected the iacv ( in the 1050 rpm position )
Then went for a short ride with the resistors installed and all went well, engine drove as usual, no change.
This morning the engine was cold when i started the bike and this was the result;
https://www.youtube.com/watch?v=lVhFQ7VpHMY
There are several other options, one example is having a two way switch change from having the iacv immobilized with the resistors or having it operate normally, this requires ;
A double pole 2 way switch, the two resistors and two connectors, one male and one female 4 pole connector.
That way it is very simple to alter the position of the iacv when the situation changes ( colder weather )
If this worked for me it may work for you, cost; 1 dollar for the two 1 watt 330 ohm resistors, what is importand is the diameter of the resistor leads which is 0,7 mm. so they fit correctly in the female connector.