12-07-2024, 05:56 AM
Just a tip for aligning the rear wheel on the cb1100;
The width of the front disks is exactly the same as the width of the rear tire, so i use a string from the front disk to the rear tire behind the sidestand spring with a clear path like this;
After the rear shaft is tight enough so it won't shift by itself adjust the two 8mm screws so the string just touches the front of the tire's edge and then tighten the shaft up to spec.
After that tighten the 8mm bolts so they won't wriggle loose, just check them after the shaft is done up.
Love this thread.
The width of the front disks is exactly the same as the width of the rear tire, so i use a string from the front disk to the rear tire behind the sidestand spring with a clear path like this;
After the rear shaft is tight enough so it won't shift by itself adjust the two 8mm screws so the string just touches the front of the tire's edge and then tighten the shaft up to spec.
After that tighten the 8mm bolts so they won't wriggle loose, just check them after the shaft is done up.
Love this thread.