06-17-2014, 02:09 AM
I have a new technique now. It takes about an hour:
Start with the Muhfuh's Mag polish. I spooge some product on the pipe, wrap a strip of tee short twice around, then pull back and forth while sliding the rag up and down. That takes the top layer of crap off.
Next is a Dremel at half speed with a metal polishing biscuit. That takes the liver spots off and starts to shine the metal.
Last is Semichrome with a rag. That evens up the shine from the Dremel, and the Semichrome leaves a protective coating.
Its a job no doubt, nut the last time I did it it looked good for a couple months. We're in the rainy season now so that may not be the case this time.
Start with the Muhfuh's Mag polish. I spooge some product on the pipe, wrap a strip of tee short twice around, then pull back and forth while sliding the rag up and down. That takes the top layer of crap off.
Next is a Dremel at half speed with a metal polishing biscuit. That takes the liver spots off and starts to shine the metal.
Last is Semichrome with a rag. That evens up the shine from the Dremel, and the Semichrome leaves a protective coating.
Its a job no doubt, nut the last time I did it it looked good for a couple months. We're in the rainy season now so that may not be the case this time.