05-05-2015, 02:10 AM
(05-04-2015, 10:58 PM)Toddman_imp Wrote: There's a good write-up about changing bars on this site. ChipBeck maybe? Anyway, it took me about 2 hours but I had to drill mine. The stock bars were too tall for me and the bend wasn't kosher for my wrists. An inch makes all the difference - insert puns here. I think the only difference of his install and mine was that I blew out the stuck rubber washers from inside the handlebars with the compressor. I also took the tank, seat and sidecovers off. It was a fun install and the new bars are black and have a real comfortable bend. Mine were from Emgo.
Gentlemen,
My handlebar thread is in the "how to" section of the forum. Or click on this link -
http://cb1100forum.com/forum/showthread.php?tid=980
Cheers.
Chip
