05-04-2015, 01:47 PM
(05-04-2015, 06:57 AM)uscgmac_imp Wrote: I've seen these bars on the website, they say no modification needed. You can use the stock brake and clutch lines. Also says compatable with the bar end weights and are predrilled. How hard were they to install for whoever has installed them.
They are a bit of a pain in the butt due to the anti-vibration bar end mechanisms you must extract from the originals, and insert into the Type 2 bars. But with some patience, epithets, and Sailor Jerry rum, it wasn't a bad hour or so.
