06-09-2015, 09:46 PM
The spark plug wrench is a thin walled 14 mm with a rubber gripper inside and the ability to use either a ratchet, or a 14mm box end wrench to loosen and tighten the plugs. It was reported by one forum member who has pulled his plugs
http://cb1100forum.com/forum/showthread.php?tid=1682
with this wrench you do not have to remove the fuel tank to remove the plugs. He did say he loosened the back of the tank and propped it up, and removed the outside plugs first. I have not had mine out yet, and might not for awhile but wanted to have plugs and wrench on hand just in case.
These plugs are very long and narrow and deeply set in the head. Threads are 26.5 mm long ( just over an inch long). Dealers do not seem to be stocking them so if you need them, they will have to be ordered.
http://cb1100forum.com/forum/showthread.php?tid=1682
with this wrench you do not have to remove the fuel tank to remove the plugs. He did say he loosened the back of the tank and propped it up, and removed the outside plugs first. I have not had mine out yet, and might not for awhile but wanted to have plugs and wrench on hand just in case.
These plugs are very long and narrow and deeply set in the head. Threads are 26.5 mm long ( just over an inch long). Dealers do not seem to be stocking them so if you need them, they will have to be ordered.