07-30-2016, 06:12 AM
You could make your own license plate bracket with a simple hacksaw and a drill. Then spray it flat black so it isn't noticeable. However, I did stumble on another option while relocating my turn signals. Let me see if I can find it again.
Here is the DIY version.
http://cb1100forum.com/forum/showthread.php?tid=567
Here is the aftermarket plate with turn signal relocation. You would need to drill 2 holes to mount it on the rear fender. You could use the existing bracket as a template for drilling the holes as well.
http://www.kuryakyn.com/products/3908/li...ght-mounts
Here is the DIY version.
http://cb1100forum.com/forum/showthread.php?tid=567
Here is the aftermarket plate with turn signal relocation. You would need to drill 2 holes to mount it on the rear fender. You could use the existing bracket as a template for drilling the holes as well.
http://www.kuryakyn.com/products/3908/li...ght-mounts